Posts

Pool Equipment Explosion.....Don't Let This Happen To You!

Image
           Pool Equipment Explosion……..                  Don’t Let This Happen To You!!!! This is what happens when a plumbing valve has a blockage.   It literally blows the equipment (pool filter in this case) to pieces.   You can note the top lid to the filter laying in the grass.   The bottom of the filter is cracked in multiple places.   The filter cartridges are off and blown to the side.   The plumbing pipes are laying on the ground in front of the remaining equipment.   This is the result of a bad installation.   We have only been called to this kind of an accident a couple times, but it sure is a mess and sure does some damage.   Luckily no one was in the area, and no one was hit, or hurt by flying parts. Please……if you have any questions about your equipment installation….. For A FREE Consult...

Pool Pump Growlng And Sounding Like It Is Gargling Rocks?

Pool Pump Growling..... Sounding Like It Is Gargling Rocks? In this case, the water doesn’t usually fill up the pump basket. That is called “Cavitation”.  Cavitating pumps make a particular growling sound, like the pump is gargling rocks, a low, grumbling sound. Pumps need a full water flow to operate properly. Poor water flow can come from:  1.     A pump too big for the water supply so it can’t fill all the way up.  Bigger is not always better.  Be sure to have the right pump to fit your plumbing or enlarge your plumbing to match the size of the pump that you want. 2.     Plumbing pipes that are too small to deliver enough water to the pump. 3.     Broken directional valves 4.     Broken check valves 5.     Too full pump basket (too much debris) 6.     Debris stuck in the impellers 7.     Debris stuck in plumbing lines 8.  ...

Remodeling When It Comes To Pebble Surface Brought Out Of The Water

Remodeling When It Comes To Pebble Surface That Has Been Brought Out Of The Water. Note: Please remember that plaster and pebble are products that need to be kept completely under water following installation to prevent cracking and crumbling.  Therefore, waterline tile is used both for cosmetic and for structural reasons by providing a air/water barrier for the plaster and pebble.  IN CASES WHERE THE PEBBLE WAS BROUGHT OUT OF THE WATER, A CORRECTION – REPAIR MUST BE MADE: Removal of waterline pebble and tile installation: There was a trend of customers not wanting to use tile and they wanted to have pebble brought out of the water.  That has caused cracking and crumbling damage to the pebble which requires the pebble around the surface of the pool to be cut out and waterline tile to be put in. We have successfully done this work for quite some time so…… For your FREE ESTIMATE, and, any additional questions, CALL DOUG 760-409-3763

Good Caulking In Your Pool's Expansion Joint Is Important!

Good Caulking In Your Pool’s Expansion Joint Is Important! Pool Caulking is what prevents water and debris from getting into the joint.  Yes, it also looks nice, but it has a much bigger reason for being there.  This caulk, the coping bead seal, and the pool waterline tile, all work together to protect the “sea Wall” under the plaster.  If the caulk line is not there, or is not done well, some very common and very expensive problems happen to your swimming pool wall. Who Needs To Caulk?    Anyone who has an  inground concrete pool with coping stones , whether they be brick, flagstone or pre-cast stones, you will have an expansion joint behind the coping stones, to allow for expansion of the pool deck when the weather gets hot. This joint should be caulked every five years or so. A  cantilever pool deck , where the pool deck extends over the pool wall without coping stones, has no expansion joint - and no need to caulk.   He...

Swimming Pool Auto-Fills or Automatic Water Levelers

Swimming Pool Auto-Fills or Automatic Water Levelers The Pool Auto-Fill is an automatic pool water leveler, designed to maintain the optimum water level in pools, spas and fountains. They are more commonly used in our valley, and in other dry and arid regions that have to add frequent make-up water. Pools lose water due to two things:   Evaporation and Leaks The reason for a pool auto-fill is to maintain a safe level of water in the pool.   If the water goes down below the skimmer, your equipment could run dry and burn out.   That is a VERY serious matter.   In the old days, a hose had to be strung to the pool on a slow drip to maintain the water level.   The Automatic Auto-Fill is a HUGE improvement!   You can safely be away from home for the day or for the season and not worry about your equipment…….as long as the auto-fill is working properly. Maintaining your Pool Auto-Fill: There is not a lot to do to keep your pool autofill o...

Thinking About Moving Your Pool Equipment Out Of The Pit?

Thinking About Moving Your Pool Equipment Out Of The Pit? In the desert in the early days, pool equipment was often put into a sub-terranean room built of cinder blocks and/or poured concrete.  This was with the double thought of equipment being both “out of sight” and “out of sound”.  It was a good thought, but has since lost favor. Why?  Because if the pool leaks, or the valves in the plumbing leak, or the equipment leaks……..you guessed it, the pit fills with water ruining all your equipment!!!! Is it a hassle to move the equipment?   YES! Is it worth it?   YES! That is why when equipment fails and is replaced, it is often moved above ground.   But even that is not a cake walk.   Let’s review the steps.   Moving the pool equipment to another location involves not only physically relocating the pump & motor, filter, heater and other equipment but also extending the pipes and the electrical power and bonding wires, to the new...

Pool Motor Making A Loud New Sound? Sounds Like A Jet Engine?

Pool Motor Making A Loud New Sound?   Sounds Like A Jet Engine? That type of sound is usually the sound of the pool motor bearings breaking down.   It can be a low and gravely or a higher pitched and whiny.   Either way, the chances are that the bearings inside the motor are grinding down and failing.   That means your pool motor is failing. There are other sounds motors can make, but they are usually short lived and sound like something rattling.   Sustained noises are always a bearing going bad. REPAIR: Sometimes, it is cheaper to rebuild the pump and motor by mating a new motor to the old pump.   Since the pump and motor came together, sometimes this fix is short lived because the pump will wear out too.   Knowing the type of equipment you have and the age of the equipment, will help make your choice. REPLACE: More often than not, it is cheaper, in the long run, to put in a new pump and motor combo with the new energy star rati...